Published papers

Replacing an N,N-dimethylamino group in a classical fluorophore with a four membered azetidine ring provides an improved luminescence quantum yield. Herein, we extended this strategy to bioluminescent firefly luciferin analogues and evaluated its general validity. For this purpose, four types of luciferin cores were employed, and a total of eight analogues were evaluated. Among these analogues, unexpectedly, only the benzothiazole core analogue benefited from an azetidine substitution and showed enhanced bioluminescence. In addition, fluorescence measurements revealed that an azetidine substitution improved the fluorescence quantum yield by 2.3-times compared to a N,N-dimethylamino group. These findings clarify the differential effects of azetidine substituents in luciferins and present one possible strategy for enhancing photon output in benzothiazole type luciferins through a synthetic approach.

This work reports a basic study to simplify urinalysis, using distance-based microfluidic paper-based analytical devices (D-µPADs) for multiplexed detection. Intuitive detection of albumin (Alb), glucose (Glu) and hemoglobin (Hb) in artificial urine samples is demonstrated by a colorimetric distance-based readout method. The response ranges for the three analytes (15-1000 mg/dL, 25-2000 mg/dL, 0.25-1.0 mg/dL), fully cover the physiologically relevant domain. User operation is limited to sample application and readout of the color-changed length corresponding to the analyte concentration.

Bio)chemical sensors based on paper substrates show attractive features such as being low cost, portable and disposable. Therefore, the technology is currently used in urinary dipsticks and immunochromatographic test strip. In recent years, many research groups report studies on microfluidic paper-based analytical devices (μPADs). In spite of the simplicity of paper-based platforms, μPADs enable performing complicated analytical procedures, multiplex target analysis and equipment-free detection. Due to these useful functions, μPADs are paid attention for point-of-care testing (POCT) and for field-deployable analysis. Herein, we introduce the fabrication methodology and clinical applications of μPADs developed by our research group.

Fluorescence and bioluminescence have been actively applied to various chemical sensors and biosensors, including to cellular/in vivo imaging. On application to the detection of specific targets, it is necessary to develop fluorescent/bioluminescent probes that selectively respond to the target analytes such as molecules, ions or cells by changing their optical properties. The authors have focused on the development of small molecular probes by means of molecular design based on the desired function. In this paper, we describe the approaches to molecular design of fluorescent/bioluminescent probes and their applications, including the introduction of our recent research works. Finally, a future outlook for further functionalization of small molecular probes is provided.

Microfluidic paper-based analytical devices (µPADs) that display semi-quantitative analysis results by reading a QR code have been developed. The only user operation required is to apply the sample and to read the displayed QR code with a mobile device to obtain the result. Copper ions were detected as a model target and the copper ion concentration-dependent display of QR codes was achieved. This simple assay method can be applied to other targets and has great potential for point-of-care testing (POCT) applications.

A challenge for paper-based cation sensors relying on classical carrier-based ion-selective optodes (ISOs) is their pH-cross response caused by the use of H+-sensitive chromoionophores as optical signal transducers. This work demonstrates fully pH-independent fluorescence-based calcium detection with a paper-based plasticizer-free ISO. To achieve a pH-independent assay, a solvatochromic dye (SD) instead of a traditional H+-sensitive chromoionophore has been applied to the paper-based ISO by means of inkjet printing technology. The detection principle depends on an ionophore-driven phase-transfer ion-exchange reaction between target cations and the positively charged SD, which no longer involves H+ in the optical signal transduction process. The developed paper-based ISOs with the SD resulted in Ca2+ concentration-dependent response curves not affected by the sample pH (pH 6.0, 7.0, and 8.0). The dynamic range obtained for Ca2+ detection was from 10−5 to 1 mol L−1 with a detection limit of 19.3 μmol L−1. Additionally, excellent selectivity derived from the used ionophore has been confirmed. As a simple practical application, the determination of Ca2+ in mineral water has been achieved without the pH-buffering process required for conventional cation-exchange ISOs.

The quantification of electrolytes in biological fluids plays an important role for evaluating the human health condition. This work proposes a disposable and simple microfluidic paperbased analytical device (µPAD) for the quantitative colorimetric detection of salivary Na+, K+ and Ca2+, relying on ion-selective optodes (ISOs). Nanoscale ISOs composed of pluronic F-127 surfactant-based micelles were used as a colorimetric indicator system, reducing the assay time compared to the previously reported bulk membrane approach. Devices consist of three functionalized paper layers assembled by lamination, with the optical signal read out from the bottom layer. Saliva was chosen as the biological specimen because it is painlessly collected and easy-to-handle, which makes it suitable for POC assays. Simultaneous Na+, K+ and Ca2+ detection by a single µPAD was successfully confirmed by using aqueous metal ion samples with various concentrations of Na+, K+ and Ca2+ within the biologically relevant range. The simultaneous detection of the three cationic species enabled the correction of the three ion quantities by eliminating the interference from other ions using the calculated selectivity coefficients. For proof-of-concept, Na+ quantification in a human saliva sample was conducted by the developed µPADs. The calibration curve for this assay was prepared by applying artificial saliva to the µPADs. The concentrations of Na+ in spiked human saliva were also measured by the µPADs. The obtained recovery rates were 78-132 %, which indicates the quantification of the added Na+ in the real sample matrix. Finally, this µPAD was successfully integrated into a smartphone-based assay, which enables salivary electrolyte quantification in resource poor settings. The developed µPADs satisfy the criteria of low-cost (< $0.3/device), rapidity (< 5 min) and simple analytical procedure compared to the conventional ion-selective electrode (ISE) method.

Bioluminescence is a powerful imaging modality for monitoring biological phenomena bothin vitroandin vivo. Bioluminescence imagin (BLI) is becoming a seamless imaging technology covering the range from cells to organs of small animals. Long-term imaging at the single cell level would lead to a true understanding of the dynamics of life phenomena. This work presents a long-term single cell bioluminescence imaging technology accomplished with C-3 position protected furimazines (FMZs), a CTZ analogues, which generate intense blue emission when paired with a highly stable engineered luciferase, Nanoluc. Four types of FMZs protected at the C-3 position have been synthesized. The type and steric bulkiness of the protection group strongly contributed to storage stability and the kinetics of the bioluminescence reactions of the analogues in human living cells. In particular, two developed FMZ analogues resulted in significantly longer bioluminescence emission with higher S/N ratio than FMZ at single cell level. Long-term bioluminescence single cell imaging technology with the developed FMZ analogues will lead to seamless imaging in the range from cells to organs of small animals.

The pyrophosphate ion (P2O74-, PPi) plays a critical role in various biological processes and acts as an essential indicator for physiological mechanism investigations and disease control monitoring. However, most of the currently available approaches for PPi species detection for practical usage still lack appropriate indicator generation, straightforward detection requirements, and operation convenience. In this study, a highly sensitive and selective PPi detection approach via the use of nanozymatic carbon dots (CDs) is introduced. This strategy eliminates the common need for metal ions in the detection process, where a direct indicator-PPi interaction is adopted to provide straightforward signal reports, and importantly, through a green indicator preparation. The preparation of this nanozymatic CDs' indicator utilizes an aqueous solution refluxing, employing galactose and histidine as the precursor materials. The mild conditions of the solution refluxing produce fluorescent CDs exhibiting peroxidase-mimic properties, which can catalyze the o-phenylenediamine oxidation under the presence of H2O2. The introduction of PPi species, interestingly, inhibits this process very efficiently, the extent of which can be colorimetrically monitored by the generated yellow product 2,3-diaminophenazine. Spectroscopic results point to CD surface functional groups' selective binding toward PPi species, which severely interferes with the electron transfer process in the enzymatic catalysis. Relying on this CD peroxidase-mimetic property inhibition, sensitive and selective recognition of PPi reaches a detection limit of 4.29 nM, enabling practical usage in complex matrixes. Owing to the superior compatibility and high stability of nanozymatic CDs, they can also be inkjet-printed on paper-based devices to create a portable and convenient platform for PPi detection. Both the solution and the paper-device-based selective recognitions confirm this unique and robust metal-free inhibitive PPi detection, which is supported by a convenient green preparation of nanozymatic CDs.

© Springer Science+Business Media, LLC, part of Springer Nature 2019. Arrays of gas sensors are of high interest for “electronic nose” applications. Here, we describe the fabrication of a colorimetric single-use gas sensor array made of paper allowing the discrimination of volatile primary amines based on their polarity. For this purpose, polymeric nanoparticles with different polarities containing an amine-sensitive chromogenic dye are deposited onto paper substrates by means of inkjet printing. Data processing is conducted by red-green-blue (RGB) color extraction, followed by principal component analysis (PCA) or agglomerative hierarchical clustering (AHC) analysis. The application to the discrimination of two cheese samples is demonstrated.